Place the fitting between the jaws of the swaging tool and compress it firmly onto the wire rope. Place a stop on each of the cut ends of the wire rope to prevent the individual wires of the rope from unraveling. Leave the required amount of space between ferrules, as well as enough rope protruding from the last ferrule for the end stops. Step 4Īrrange the assembly carefully for swaging once made, the connection is permanent. For a loop, pass the end of the rope back through the remaining openings in the ferrules, forming the appropriately sized loop. For a splice, place the ferrules in a row with the ends of the two ropes passing through them in opposite directions. Slide the required number of ferrules onto the wire rope. Keep the ends of the rope as compact as possible. Use a sharp, fine hacksaw blade to make sure all cuts are clean. Step 2Ĭut the wire rope to the correct size using a cable cutter or hacksaw. More rope is usually required for a side-by-side splice than for a small end loop. Include extra length for the intended application of the ferrule and stop. How To Install A Wire Rope Ferrule & End Stop Step By Step Step 1ĭetermine the amount of wire rope needed for the project at hand.
0 Comments
Leave a Reply. |